Scheduled transactions bug

May 09, 2011 5 Replies

It is a nice feature that by right-clicking on a transaction you can get to the scheduled transactions sheet which is in general all filled out already. But I find that there's no way to say okay, or go ahead or I accept, etc. the window just sits there. The enter key does nothing and in fact it's hard to get off that sheet, although the escape key worked at times. I have tried numerous times to enter one trial transaction for June 3 and in looking around (e.g. managing transactions) find that there is no evidence that it was registered. (I also faked a May date to no avail). The page is replete with blank areas and it must betoo big because it pushes the right-hand column, which appears to be a series of help questions, so only 50% of it is can be read. May be the OK button is off the screen but the screen cannot be scrolled or moved (XP 2) Q10.



John Polasek


I suspect that has something to do with your Windows settings. I have the OK button at the lower right on mine.

Try checking your display on the control panel. I have my resolution at 1366X78. I think that also controls the size of the pictures.

It sounds like you might have something there. Unfortunately when I tried to change from 1024 x 768 to 1280x 1024, the change wouldn't stick and it reverted to the old setting, with the message "input not accepted". I have an old 15 inch Acer monitor. It looks like the right-corner OK button will be forever out of reach. I guess there might be some kind of a workaround I might come across. Thank you

I think I see-they are thinking everyone has one of those widescreen monitors so they can watch movies so the aspect ratio is wrong-my 21 inch monitor blew out so I'm back to using a square one. John Polasek

Try adjusting the manifier, the % shown in the lower right of the screen. I often set it upto 125% to aid in reading complicated pages, but then forget to reset it. The result is I can't pan around properly.

No I did not find a magnifier. But back at the control panel\display I was able to set to a higher resolution and it stuck, but it was accompanied by a gray box continuously marching on diagonals across my screen (and no way to get rid of it) " input not accepted". While in this condition I was able to see and press the OK button and install one scheduled transaction so I guess that will be my procedure: change to the rather unpleasant higher resolution with the funereal gray box and then add all my scheduled transactions in a batch. Incidentally, I am using the latest revision R10. Thank you for your helpful suggestions. John Polasek

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required