I am attempting to install a couple of Ithaca PosJet 100 printers. I get install done, but when starting POS, I get an "Warning 920 Failure was detected in the printer opos drivers" Deleted drivers, re-installed. The printers are attached to LPT1, and the cash drawer is in serial with the printer. In other words, the drawer is cabled to the computer and the printer is then cabled to the drawer. Could this be the problem?
Bud
I am attempting to install a couple of Ithaca PosJet 100 printers. I get install done, but when starting POS, I get an "Warning 920 Failure was detected in the printer opos drivers" Deleted drivers, re-installed. The printers are attached to LPT1, and the cash drawer is in serial with the printer. In other words, the drawer is cabled to the computer and the printer is then cabled to the drawer. Could this be the problem?
Bud -- If we can''''t pet it, you don''''t want it.
Jeff, thanks for reading this. I have opos drivers, and it is recognizing the printer, but gives an error 920 stating that the driver has a problem. I reinstalled, even went ack a couple of versions. When RMS doesn't see the printer it gives a error 919. Does the fact I am sending print commands thru the drawer then to the printer cause problems?
Jeff, thanks for reading this. I have opos drivers, and it is recognizing the printer, but gives an error 920 stating that the driver has a problem. I reinstalled, even went ack a couple of versions. When RMS doesn't see the printer it gives a error 919. Does the fact I am sending print commands thru the drawer then to the printer cause problems? -- If we can''''t pet it, you don''''t want it.
"Jeff @ Check Po
BeanSmart website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.