Verifone PinPad 1000se - Packet Setup - Pls Help

I cannot figure out what format the packet needs to be to send and receive data via Serial (usb).
ie DATA {LCR}
With a Com port viewer I can see only the EOT symbol when the cancel button is pressed on the keypad.
I have tried Hex, ASCII, DEC, base64 and Binary. Just cant communicate with this device. All communication protocol settings are correct.
- Half Duplex - 9800 Baud rate - 7 data bits - Even Parity - 1 stop bit
Any hint would be very helpful. Thanks.
Reply to
p.horton1

BeanSmart website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.